Replacing The Intake Valve On My Samsung Washer

 I have been having a issue with the water flow in to my washer for awhile. I cleaned the filters that filter the water going in to the washer. I was still getting the error code that the washer was not getting water when in switch into the raise cycle. So when I had time, I took the back of the washer off the washer to check the inside of the washer. I ran the washer an check the intake valve. The one of the solenoids felt hot as the washer ran through its cycles. I figure that valve that it was over was clogged.



I looked the part up online. I ordered the part I needed. I had to wait to a day I had time to replace the intake valve before heading to work. On Saturday, I set in on replacing the intake valve. The whole process went a lot easier and quicker then I thought it would. It took me less then 30 minutes from start to finish. That includes the testing for leaks. Now the washer is running like it should again.



As you can see from the picture above, the one valve was clogged. I am glad that the washer is working right now and I was able to fix it myself.


Comments

Popular posts from this blog

Chick-fil-a's Polynesian Sauce in Stores

Go To A Party